9″ Sediment and Disruptor® Replacement Filters for PFAS Compounds, Chlorine Taste and Odour, VOCs, Cyst, Lead, Chloramine, Bacteria and Viruses Reduction

Each filter measures 9″ x 2.5″

• PFOA (Perfluorooctanoic Acid) > 98.9%
• PFOS (Perfluorooctane Sulfonic Acid) > 99.0%
• Total Chlorine (Chloramines) > 99.3%
• Free Chlorine > 99.5%
• Lead (Pb) > 99.4% @pH 6.5
• Lead (Pb) > 99.4% @pH 8.5
• Copper (Cu) > 99.9% @pH 8.5
• Copper (Cu) > 99.9% @pH 6.5
• E.Coli (Total Coliforms) > 99.9999%
• Coliphage (Bacterial Virus) 99.9995%

Actual performance results may vary based on the level of organic contaminants in the influent water, changes in pH and upon other conditions that may be encountered during actual use.

• 1st Stage Filter: 100% Polypropylene triple gradient sediment filter.
  • Capacity: Dependant on Water Quality
  • Protects the 2nd Stage Aragon Filter from damaging/blocking prematurely
  • Triple gradient Sediment Filter
  • Porosity: 1 Micron Nominal

• 2nd Stage Filter: The AquaCo® 9″ x 2.5″ Disruptor® Filter Cartridge offers cutting-edge, broad-spectrum water purification through an innovative multi-stage design.
  • Combines electroadsorptive nanotechnology, high-performance activated carbon block, and submicron membrane filtration to deliver advanced, multi-stage contaminant reduction — all in a single, compact unit.

• To ensure optimal performance and hygiene and to prevent build up of contaminants, we recommend that filters are not used any longer than 12 months. However, replacement frequency depends on water quality and usage.
• Filters should also be changed when rated capacity is reached, or when flow becomes too slow.

Click here to watch Twin Undersink Servicing Video

Twin Undersink Installation Images

Twin Undersink Water Filter Installation Guide

• Min. Operating Temperature: 0.6 °C
• Max. Operating Temperature: 38 °C
• Min. Working Pressure: 25 psi
• Max. Working Pressure: 125 psi
• Flow Rate: 3 LPM

• For Cold water use only. Install on COLD water lines only.
• Never install or operate where inlet water pressure may exceed 120 psi (827kPa)
• Protect from freezing. Remove filter if temperature drop below 1°C.

• Sediment Filter Certifications:
  • Tested and Certified by NSF International under NSF/ANSI Standard 42 for material requirements only and and FDA CFR Title 21.

• Disruptor® Filter Certifications:
  • Tested to NSF/ANSI 42 & 53 aesthetic effects and health effects testing.
  • Independently laboratory tested by SGS for proven performance, including rigorous volume-based testing to ensure consistent purity throughout its lifespan.